Configuring external system settings

You can use the following steps to define values for external system configuration settings using the Interface Settings window.

Note: These configuration settings are also available in Configuration File Maintenance. For information about the configuration settings that can be set using the Interface Settings window, see Using the Interface Settings window.

To configure external system settings:

Click System > Interface Settings.
The Interface Settings window is displayed.
Select the external system from the drop-down list.

The Interface Settings window is displayed.

Tip: Some settings are duplicated in different sections of the settings tree. You will see multiple settings highlighted in green when a setting with a duplicate is selected.
Select the external system using the top-left drop-down list.

The settings for the selected external system are displayed.
Select the setting to be configured. For example, Address Validation confirmation alert.
The selected setting and all other settings at the same level of the settings tree are displayed.

Note: You can use the Outbound and Inbound items to map Synergetic lookup table values to external system values. See Configuring external system lookup table mapping.
Configure the selected setting as required. Depending on the external system and setting selected, you can:

• Use the slider to turn the setting on or off.

• Type a value for the setting into the field provided.

• Select a value from a drop-down list.

Note: Some external systems do not have settings configuration. They only allow lookup table mapping. If this is the case for the selected external system, proceed to Step 7.
Click to save your changes.

Note: You are prompted to save changes before navigating to a different set of external system settings.
Repeat steps 4 and 5 until all settings have been configured.
Click to refresh the changes.