Page Comparison

You can configure interface settings and lookup table mapping to determine the settings and lookup table values used when interfacing with external systems.To configure interface settings and lookup table valuesuse the following steps to define values for external system configuration settings using the Interface Settings window.

Note: These configuration settings are also available in Configuration File Maintenance. For information about the configuration settings that can be set using the Interface Settings window, see Using the Interface Settings window.

To configure external system settings:

1. Click System > Interface Settings.
   The Interface Settings window is displayed.
   
2. Select the external system from the drop-down list.
   
   The Interface Settings window is displayed.
   
   
   Tip: Some settings are duplicated in different sections of the settings tree. You will see multiple settings highlighted in green when a setting with a duplicate is selected. 
   
   
3. Select the external system using the top-left drop-down list.
   
   The settings for the selected external system are displayed.
4. Select the setting to be configured. For example, Address Validation confirmation alert.
   The selected setting and all other settings at the same level of the settings tree are displayed.
   
   
   Note: You can use the Outbound and Inbound items to map Synergetic lookup table values to external system values. See Configuring external system lookup table mapping.
   
5. Configure the selected setting as required. Depending on the external system and setting selected, you can:
   
   • Use the slider to turn the setting on or off.
   
   • Type a value for the setting into the field provided.
   
   • Select a value from a drop-down list.
   
   
   Note: Some external systems do not have settings configuration. They only allow lookup table mapping. If this is the case for the selected external system, proceed to Step 7. 
   
   
6. Click  to save your changes.
   
   Note: You are prompted to save changes before navigating to a different set of external system settings.
   
   
   
7. Repeat steps 4 and 5 until all settings have been configured.Select either:
   • Inbound to map inbound external system values to Synergetic lookup tables values.
   • Outbound to map outbound Synergetic lookup table values to external system values.
   Note: Lookup table values are not currently mapped to the myEdOnline external system.
   The lookup tables are displayed.
   Image Removed
8.  Select the lookup table.
   The mapping table is displayed.
   Image Removed
Click Image Removed next to the first value to be mapped.
The mapping drop-down list is displayed.
Image Removed
Note: The Image Removed icon is displayed when there are unmapped values.

9. Select the value that best represents the corresponding lookup table or external system value.
   Image Removed
   The value is mapped.
10. Repeat steps 10 and 11 until all required values are mapped.
    Note: The Image Removed icon is displayed when there are unmapped values.
11. Click  to refresh the changes.